Jump to content

Error 53


krosefree

Recommended Posts

Hello,

 

I've been trying to implement an application using the state machine template. Using Javier Ruiz's excellent webinar as a guide, I configured the template using a 9022 RT with a 9116 chassis. The FPGA code runs well but I get this message when executing the RT:

 

Error 53 occurred at Property Node (arg 1) in RT Main.vi

Possible reason(s):

LabVIEW: Manager call not supported.

 

I am using LV 2014sp1.

 

I've tried this using the 9024 RT and a sbRIO9641 - both issue the same error.

 

Any ideas as to my (obvious) incompetence?

 

Thanks!

Link to comment
Share on other sites

Hello Krosefree,

 

Thank you for your post and your comments about the webinar. I am glad you found it useful. The error you are seeing is not at all your fault, but it is due to the type of RT target you are using. Those targets will not support the FP.Open property or invoke nodes that the JKI State Machine uses on the "UI: Front Panel State". But, fear not, the solution is to disable (or conditionally disable) those elements as shown here: http://www.screencast.com/t/KgBZmgfF

 

Please let me know if you have any more comments or questions.

 

Best regards,

 

Javier Ruiz

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.