Mass Compile on OS X

[sth]

I seem to be getting a whole host of issues…. I am installing a clean reference system for LV.

I can use VIPM if I carefully only use the admin account I installed VIPM from and not other admin accounts.

 

BUT, after the install, it should do a Mass Compile of the packages since I have set that option.

 

I get a message at the bottom "Connecting to LabVIEW 2014 (64 Bit) Timeout NNN" where NNN counts down from 120 seconds.

 

I have verified the connection to LabVIEW 2014 (64 bit) (on Port 3370) and it seems to be correct. Is the Mass compile command connecting on a default port?

 

I will do the manual mass compile since it does install the packages.

 

It would be very very nice if VIPM used a LabVIEW 2014 run time. LV 13 and previous have a scrolling bug where if the window is scrolled to the bottom if you go 1 pixel too far the window jumps to the top. This has been fixed in both 32 and 64 bit LabVIEW 14.

 

-Scott